Back to products
Electronics
- All products
- 3D Printer64 products
- Books0 products
- Devices3 products
- Electrical71 products
- Our Products1 product
- OUR ROBOTS4 products
- Power Supply8 products
- Sensor23 products
- SERVICES PROVIDED2 products
- TOBOIDS auto0 products
- TOBOIDS AUTOMATA0 products
- Electronics61 products
- Mechanical31 products
- Lighting4 products
IOT-BOARD BOT_LOG V1
OVERVIEW
- Model: BOT_LOG V1
- Power input: 4.5V ~ 9V (10VMAX),
- Transfer rate: 110-460800bps.
- Support: SD card, integrated clock module, Arduino platform.
- Working temperature: -40°C ~ + 100°C.
- Form factor:60mm x 45mm.
- Flash size: 4MByte
-
Requires 30 days of lead time.
-
Minimum order quantity of 2.
IRF520 MOSFET Driver Module for Arduino ARM Raspberry pi
IRF520 MOSFET Driver Module for Arduino Raspberry Pi is a breakout board for the IFR520 MOSFET transistor and is designed to switch heavy DC loads from a single digital pin of your microcontroller. Its main purpose is to provide a low-cost way to drive a DC motor for robotics applications, but the module can be used to control most high current DC loads.
LM2596 DC-DC Buck Converter Adjustable Step Down Power Supply Module
DC-DC Buck Converter Step Down Module LM2596 Power Supply is a step-down(buck) switching regulator with high-precision potentiometer, capable of driving a 3-A load with excellent line load regulation and high efficiency.The LM2596 series operates at a switching frequency of 150kHz, thus allowing smaller sized filter components than what would be required with lower frequency switching regulators.
LM358 Dual Operational Amplifier
OVERVIEW
No. of channels: dual channel Supply voltage: 3v to 32v Max. Operating Current (mA): 0.35 Gain-Bandwidth Product: 700 kHz Slew rate: 0.3 V/us
MAX4466 Electret Microphone Amplifier with Adjustable Gain Module
- Supply Voltage Operation: +2.4V to +5.5V.
- Versions with 5nA Complete Shutdown Available only (MAX4467/MAX4468).
- Excellent Power-Supply Rejection Ratio: 112dB.
- Excellent Common-Mode Rejection Ratio: 126dB.
- High AVOL: 125dB (RL = 100kΩ).
MEGA 0E5 5W CERAMIC RESISTOR
- 0.5 Ohm 5 Watt Cement Resistor
- Resistor Type: Fusible Cement
- Resistor Value: 0.5 Ohm
- Wattage: 5 Watt
Micro SD Card Reader Module
OVERVIEW
- Power supply: 4.5V – 5.5V, 3.3V voltage regulator circuit board
- Positioning holes: 4 M2 screws positioning hole diameter of 2.2mm
- Control Interface: GND, VCC, MISO, MOSI, SCK, CS
- Size: 45 x 28mm
- Net weight: 4.2g
MT8870 DTMF Decoder Module
The MT8870 module is a complete DTMF receiver integrating both the band-split filter and digital decoding functions. This detection module interprets the incoming tone and produces a coded output that can be connected to all manner of microcontrollers.
NEO 7M GPS With Compass for Pixhawk 2.4.6/2.4.8
Neo 7M GPS module that includes an HMC5883L digital compass is a high sensitivity, low-power GPS module that has 56 channels and outputs precise position updates at 10Hz.This GPS module also comes with a molded plastic case which keeps the module protected against the elements making it ideal for use on your aircraft or quadcopter.This Neo 7 module also includes a rechargeable backup battery to allow for HOT starts and also includes an IC EEPROM to store the configuration settings.
NEO-6M GPS Module with EPROM
NEO-6M GPS Module with EPROM is a complete GPS module that is based on the NEO-6M and uses the latest technology to give the best possible positioning information.This module can save the data if the main power is shut down accidentally and its 3mm mounting holes can ensure easy assembly.
NODEMCU – ESP8266 Wi-Fi Development Board
OVERVIEW
- Model: ESP8266
- Power input: 4.5V ~ 9V (10VMAX), USB-powered
- Transfer rate: 110-460800bps
- Support: UART / GPIO data communication interface, Smart Link Smart Networking
- Working temperature: -40°C ~ + 125°C
- Drive Type: Dual high-power H-bridge
- Flash size: 4MByte
Op-Amp LM741
- No. of channels: 1 channel.
- Supply voltage: 10v to 44v
- Low Input Offset Voltage: 2 mV
- Gain-Bandwidth Product: 1 MHz
- Slew rate: 0.5 v/us
