Shop
- All products
- 3D Printer64 products
- Books0 products
- Devices3 products
- Electrical71 products
- Our Products1 product
- OUR ROBOTS4 products
- Power Supply8 products
- Sensor23 products
- SERVICES PROVIDED2 products
- TOBOIDS auto0 products
- TOBOIDS AUTOMATA0 products
- Electronics61 products
- Mechanical31 products
- Lighting4 products
MPU9250 9-Axis Attitude Gyro Accelerometer Magnetometer Sensor Module
MPU9250 9-Axis Attitude Gyro Accelerator Magnetometer Sensor Module that features the MPU-9250, which is a multi-chip module (MCM) consisting of two dies integrated into a single QFN package. One die houses the 3-Axis accelerometer and gyroscope and the other die houses the AK8963 3-Axis magnetometer. Hence, the MPU-9250 is a 9-axis Motion Tracking device that combines a 3-axis accelerometer, gyroscope and magnetometer, and a Digital Motion Processor (DMP).
MT8870 DTMF Decoder Module
The MT8870 module is a complete DTMF receiver integrating both the band-split filter and digital decoding functions. This detection module interprets the incoming tone and produces a coded output that can be connected to all manner of microcontrollers.
N20 12V 300RPM Micro Metal Gear Motor With Encoder
OVERVIEW
- Rated Operating Voltage (VDC): 12
- No Load Current (mA): 50
- Stall Current (A): 0.3
- Rated Speed (RPM): 240
- Rated Torque(kg-cm): 0.5
- Stall Torque(Kg-Cm): 4
- No load Speed (RPM): 300
- Gear Ratio: 100 : 1
- Gear Type: Metal
- Shaft Type: D-type Single Side
NEO 7M GPS With Compass for Pixhawk 2.4.6/2.4.8
Neo 7M GPS module that includes an HMC5883L digital compass is a high sensitivity, low-power GPS module that has 56 channels and outputs precise position updates at 10Hz.This GPS module also comes with a molded plastic case which keeps the module protected against the elements making it ideal for use on your aircraft or quadcopter.This Neo 7 module also includes a rechargeable backup battery to allow for HOT starts and also includes an IC EEPROM to store the configuration settings.
NEO-6M GPS Module with EPROM
NEO-6M GPS Module with EPROM is a complete GPS module that is based on the NEO-6M and uses the latest technology to give the best possible positioning information.This module can save the data if the main power is shut down accidentally and its 3mm mounting holes can ensure easy assembly.
NITRILE RUBBER O RINGS (PACK OF 10)
An O-Ring is a simple and versatile ring-shaped packing or sealing device with a circular cross section. It used in industries to seal off or prevent leakage of fluid or gas in any application and is suitable for both static and dynamic sealing.
NODEMCU – ESP8266 Wi-Fi Development Board
OVERVIEW
- Model: ESP8266
- Power input: 4.5V ~ 9V (10VMAX), USB-powered
- Transfer rate: 110-460800bps
- Support: UART / GPIO data communication interface, Smart Link Smart Networking
- Working temperature: -40°C ~ + 125°C
- Drive Type: Dual high-power H-bridge
- Flash size: 4MByte
Op-Amp LM741
- No. of channels: 1 channel.
- Supply voltage: 10v to 44v
- Low Input Offset Voltage: 2 mV
- Gain-Bandwidth Product: 1 MHz
- Slew rate: 0.5 v/us
Optical Endstop Light Control Limit Optical Switch
OVERVIEW
- Cable Length (cm): 50
- Dimensions: 33x 10x 19
- Weight (gm): 6
PAM8403 Audio Amplifier module
OVERVIEW
- Dual channel stereo, high output power (3 w + 3 w power @ 5V and 4 ohms load)..
- Double panel wiring solves crosstalk.
- Super mini design allows it to be easily placed in a variety of digital products.
- 3W Output at 10% THD with a 4ΩLoad and 5V Power Supply.
- Filterless, Low Quiescent Current and Low EMI and Low Noise.
- Short Circuit Protection and Thermal Shutdown
Passive infrared sensor (PIR) Motion Sensor Detector Module HC-SR501
OVERVIEW
- Infrared Sensor with Control Circuit Board
- The Sensitivity and Holding Time Can be Adjusted
- Wide Working Voltage Range: DC 4.5V- 20V
- Current Drain: <60uA
- Detection Angle: <140°
- Detection Distance: 3 to 7m
- Blockade time: 2.5s
- Work temperature: -20-+80°C
- Dimension: 3.2cm x 2.4cm x 1.8cm (Approx)
- Weight: 6g
PCA9685 – 16 Channel 12-Bit PWM Servo Motor Driver I2C Module For Arduino
PCA9685 - 16 Channel 12-Bit PWM Servo Motor Driver I2C Module can control upto 16 free-running PWM outputs with only 2 pins using I2C on Arduino or other Development boards.It is a I2C-controlled PWM driver with a built-in clock and is 5V compliant, which means you can control it from a 3.3V microcontroller and still safely drive up to 6V outputs. Moreover you can chain up to 62 of them to control up to 992 servos - all with the same 2 pins.
